您当前的位置：首页 | Plating equipment maintenance and repair reduce production costsPlating equipment maintenance and repair reduce production costs
Plating equipment maintenance and repair reduce production costs
Plating equipment is an important condition for electroplating production, industrial production must be carried out to certain investment, the use of investment funds for the purchase of a variety of plating equipment, however idle or after prolonged use, plating equipment will have varying degrees of wear and tear. Expensive new equipment, if the total continue to buy new equipment to solve the problem of wear and tear, which will give the enterprise caused no small economic pressure. Therefore, to ensure normal production and operation conditions, how to carry out maintenance and repair of equipment, you can minimize the cost of production?
Routine maintenance and repair
Plating equipment maintenance include: ① rack repair and maintenance. Periodically check whether the stainless steel surface deformation, check for any loose mounting screws passing, is missing and wear, clean the surface of dust to ensure the rack clean. ② crane repair and maintenance. Check whether the machine to normal operation, if there is an unusual noise, braking performance on a regular basis for debugging. Tightness bearing and bearing lubrication, loosening the need for timely tightening, who lives opposite this requires the right amount of grease. ③ swing mechanism repair and maintenance. Some time to check every seat reducer tightness, vibration want to appear weak severe wear situation requires immediate replacement. ④ filtration system repair and maintenance. To ensure that filter traffic, often enjoy the clear filter of the filter or replace.
Plating equipment parked for a long time how to care.
Equipment is not used for some time to be placed, which requires Note: Place the floor can not have water, to ensure that equipment collocated dry and ventilated place, equipment, motor protections are available to take Wrapped. To prevent rust bearings in place of money to be injected grease.
Restart plating equipment to do the inspection
Equipment is not used for a long time after the restart before all remove all sealed plastic wrap, check the contact between the parts, to replace aging power cord, check the fastening screws, stainless steel equipment to fully clean the surface, ensure clean and beautiful, and ultimately enabled the sensitivity of the test equipment.